Tag Archives: eagle

Schematic & PCB #2

I finally finished the schematic and PCB and will send them to DirtyPCB today.

It is in HAT format ready to be used with the new (when it’s released) Raspberry PI A3.

It supports either a RF4463F30 or a RFM22B (on the back side) connected to SPI2, a MPU9250 IMU and MS5611 baro connected to SPI1 and/or another set of MPU9250 & MS5611 connected to I2C.

On the same I2C there is an ADS1115 for current/voltage sensing and 2 extra ADC pins broken out on a separate controller.

PIGPIO is connected to 6 PWM pins – 4 for motors and 2 for a gimbal.

In the end I also had sufficient space to include 3 NeoPixels (or WS2812b) RGB LEDs to show various status info. They are all driven by only one GPIO using a serial-like protocol and I think I can make this work with the PIGPIO wave functions.

 

In a future revision I might add a buzzer for alerting comm errors – like link lost – and expose 2 more PWM outputs.

 

First I have to check if the PCB will be manufactured ok.

 

Some screenshots:

 Update July 14th: 

I made some tweaks to the SCH and PCB to include a diode for the leds, according to Adafruit.

In the previous version I was powering the LEDs from 3.3V which is below their minimum voltage. Datasheet here.

To fix this I routed the led VCC to 5V but through a diode.
The WS2812b leds expect the high input voltage to be within 0.7 VCC. With a 5V VCC this results in a 3.5V high level. The raspberry pi provides a reliable 3.3V on the GPIO and there was the risk of the leds failing to understand the PI. There are 2 solutions – a level converter to increase the high level of the PI to 5v or lowering the VCC of the leds a bit. I choose the second ’cause it’s way simpler. A diode drops the voltage from 5V to ~4.3V which in turn drops the expected high level to a convenient ~3V.

Two other changes that I did are:

  • Fixed some signal traces that were running parallel on the top and bottom sides – like the I2C and some PWM outputs. Not sure how important it is but just to avoid any nasty coupling
  • Broken out the I2C to a pin header to eventually connect a PX4Flow.

The board is in production now and I really hope it gets here by Friday.

 

In the meantime I’m investigating a PPM input solution in case I want to use a standard RC system with this board.

 

Advertisements

Schematic & PCB

The Silk FC schematic is finished and the PCB is 70% done.

Here are some screenshots:

 

There is a bit of wiring acrobatics with the PWM connector as I couldn’t find an eagle 6×3 header so I improvised one from 3 2×3 headers… Ugly but it works.

As soon as they are done I will put them on github.

The board is 2 layers only and has the specs from my last post.

I intend to add a footprint for a RFM22B as well as the RF4463F30 so I can choose which to use, in case one of them has issues.

The board should work in both single-imu-baro more and also in dual-imu-baro.

I got 2 MPU9250 and MS5611 from my previous Drotek 10 DOF boards with a bit of hot air.

 

I’m really curious how it will end up as this is my first SMD board and especially my first QFN package. The MPU is really really tiny – like 2 square millimeters.